LR line level crossover

Design and use of Chokes for PS, anode and filament use.
Post Reply
dave slagle
Posts: 2085
Joined: Sat Jan 22, 2005 3:54 am
Location: NYC
Contact:

LR line level crossover

Post by dave slagle »

I ripped of mister bench again and reworked his tone controls into a line level crossover. It adjusts from ~125 to 500hz in 12 steps and each channel has a 0 to -10dB autoformer attenuator on the output.

The plot below is how it looks when driven from a 600 ohm source set for a 250hz crossover point.

the two overlapping plots are L & R channels into a 47K load and the third trace is the left channel unloaded.

dave
Attachments
There are no samples between 1K and 10K which accounts for the seeminly odd filter behavior.  a sample at say 4K should correct the shape and make it "look" right.
There are no samples between 1K and 10K which accounts for the seeminly odd filter behavior. a sample at say 4K should correct the shape and make it "look" right.
Picture 3.png (125.32 KiB) Viewed 5641 times
The values are not my final ones, but you get the idea.
The values are not my final ones, but you get the idea.
Picture 5.png (44.95 KiB) Viewed 5641 times
LR Xover.asc
(4.35 KiB) Downloaded 472 times
Post Reply