80% 50hy 35ma plate choke

Design and use of Chokes for PS, anode and filament use.
Post Reply
dave slagle
Posts: 2085
Joined: Sat Jan 22, 2005 3:54 am
Location: NYC
Contact:

80% 50hy 35ma plate choke

Post by dave slagle »

here are the plots for a plate choke to be used in a direct coupled stacked supply amp where the voltage drop across the plate choke biases the output tube.

the DCR of the choke is 1720 ohms so if the driver runs 35ma the output tube will bias up at -60V

dave
Attachments
if you don't need the 35ma of current, you can get some extra inductance.
if you don't need the 35ma of current, you can get some extra inductance.
image001.gif (8.06 KiB) Viewed 6508 times
dave slagle
Posts: 2085
Joined: Sat Jan 22, 2005 3:54 am
Location: NYC
Contact:

Post by dave slagle »

a lower DCR was requested so here is a 1180 ohm version on the same core
Attachments
image001.gif
image001.gif (9.2 KiB) Viewed 6485 times
Post Reply