See the attachments below for stuff that needs to go. New Stuff always appears at the top.
Paypal preferred but other methods accepted.
dslagle@earthlink.net
dave
Garage Sale
-
- Posts: 2092
- Joined: Sat Jan 22, 2005 3:54 am
- Location: NYC
- Contact:
Garage Sale
- Attachments
-
- Single dual bobbin choke on a Large amorphous core. Approximate dimensions are 5X5X5 inches and weight is just under 10 pounds. Two windings on a split bobbin for series / parallel connection. $200
- Picture 5.png (28.56 KiB) Viewed 6531 times
-
- single large amorphous choke wound with 5X26 litz wire. could be used as a low current high inductance PS choke or as a filament / offset winding choke. $200 (will wind a mate for $200 if a pair is needed)
- Picture 6.png (66.65 KiB) Viewed 6531 times
-
- Pair of large 25:1 amorphous outputs. Originally intended for biamping, A cancel winding can be added to up the inductance for full range. Size is 5X5X5 and they weigh in at just under 10 pounds each. $500
- Picture 4.png (87.16 KiB) Viewed 6531 times
-
- Small 80% nickel PS choke gapped for the reqired current. 34 ohm DCR. all brass hardware $65.
- Picture 8.png (25.02 KiB) Viewed 6737 times
-
- Small 80% nickel PS choke gapped for the reqired current. 54 ohm DCR. all brass hardware $65.
- Picture 9.png (24.46 KiB) Viewed 6737 times
-
- Vintage Stancor bobbin placed on an 80% nickel core. Currently gapped for 40hy 20ma 580 ohm DCR all brass hardware. $75
- IMG_3537.JPG (56.46 KiB) Viewed 6737 times
-
- Pair of Amorphous Plate/PS chokes. 240 ohms DCR Gapped for desired current open frame Not for choke input. Approximate size 2X3X3 $200
- Picture 6.png (24.66 KiB) Viewed 6740 times
Last edited by dave slagle on Tue Sep 25, 2007 1:24 am, edited 3 times in total.
-
- Posts: 2092
- Joined: Sat Jan 22, 2005 3:54 am
- Location: NYC
- Contact:
updated.
removed the sold stuff and added some new stuff.
dave
dave