LCR inductor hookup.

the road not taken.
Post Reply
dave slagle
Posts: 2085
Joined: Sat Jan 22, 2005 3:54 am
Location: NYC
Contact:

LCR inductor hookup.

Post by dave slagle »

Here is the general hookup procedure for the LCR inductors.

They are wound with 2% taps so you get approximately a +-12% range from the "Bogey" value from the schematic. This tap almost always falls at the end opposite the start and I suggest starting there.

Image

When you run the frequency sweep of the finished phono you can look for and adjust for deviations by looking at the two following sims that represent the range of taps.

The larger value choke:

Image

The Smaller Value Choke

Image

Finally here are the complete values for a 7320 ohm LCR unit. (no Neuman time constant)

Image
Attachments
LCR wiring.jpg
LCR wiring.jpg (97.85 KiB) Viewed 13701 times
Screen shot 2013-03-01 at 5.10.54 PM.png
Screen shot 2013-03-01 at 5.10.54 PM.png (18.15 KiB) Viewed 13701 times
Screen shot 2013-03-01 at 5.08.54 PM.png
Screen shot 2013-03-01 at 5.08.54 PM.png (20.09 KiB) Viewed 13701 times
Screen shot 2013-03-01 at 5.05.42 PM.png
Screen shot 2013-03-01 at 5.05.42 PM.png (22.98 KiB) Viewed 13701 times
Get Your Fix
www.hifiheroin.com
Post Reply