Sounds good - I'm glad you found the issue quickly!
I'll post when I've made progress too, I'm tied up with other jobs at the moment
Search found 10 matches
- Wed Jul 31, 2019 8:57 pm
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
Thank you! Some on its way now. I've also ordered some RCA sockets with external securing nuts and a ground post, so should be ready to start installation very soon. I'm planning to make a couple of hoop clamps like the one posted above, with the intention of mounting both them and some feet through...
- Mon Jul 29, 2019 12:50 am
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
- Tue Jul 23, 2019 1:34 am
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
- Mon Jul 22, 2019 1:38 am
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
Looking at the datasheet for the 1458C4, the top and bottom covers are steel, but the front and back plates are aluminium. I'm guessing that is not appropriate if we are looking for all around magnetic screening, so I'm now searching again. I may go back to the 1441-20 as it's all steel, albeit 20 g...
- Sun Jul 07, 2019 2:17 am
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
- Tue Jul 02, 2019 10:25 pm
- Forum: Phono
- Topic: Shielding SUT's
- Replies: 27
- Views: 14701
- Sun Jun 30, 2019 5:48 pm
- Forum: Phono
- Topic: Audio Note IO Sut
- Replies: 4
- Views: 4831
Having checked with other users of IOs, they do apparently like to be loaded close to or within the recommended range, so ideally I'd like to go with 1:100. That way, I can try the original 47k input with the cap removed to apply a nominal 4.7 ohm load without too much capacitance effect and without...
- Fri Jun 28, 2019 12:44 am
- Forum: Phono
- Topic: Audio Note IO Sut
- Replies: 4
- Views: 4831
Hi Dave, The phono preamp is an older Audio Innovations P2, which has loading in the form of a 47 kohm resistor and a 51 pF cap in parallel on the input to the first tube (ECC83 half), so I guess it's likely to be fairly close to your estimate of the 1:100 case. The cart is recommended to be given a...
- Wed Jun 26, 2019 9:54 pm
- Forum: Phono
- Topic: Audio Note IO Sut
- Replies: 4
- Views: 4831
Thanks for your original write-up, Dave - very informative and helpful! I'm looking for a SUT (pair) to match a low-impedance and very low o/p cartridge (Audio Note IO) to a MM phono stage. Specs are: Cart internal impedance 1 ohm, matching impedance 3-4 ohms, output 0.04 mV; Phono amp input impedan...